Rosineer PRESSO PRO Quick Start Guide
1. Place the PRESSO PRO on a sturdy flat surface and remove the plates shield (cover). Plug in the press machine.
2. Flip the switch to turn on the press. Its control panel lights up.
3. Enter your desired press parameters (temperature, time, and temperature scale) using the press control panel. Please follow the press manual for detailed descriptions and visual guides or see the video below (the control panel is universal for all our presses).
4. Wait until the plates reach the set temperature.
5. Position your material in the center of the bottom plate.
6. Push Down button to lower the top platen and start pressing.
7. Start the timer by pressing Timer button.
8. When the timer countdown ends, press Timer button again to turn it off.
9. Push Up button to release the plates.
10. Remove your pressed material using tools or heat resistant gloves.
| Amount Per Load: | Up to 7 grams* |
|---|---|
| Recommended Accessories | |
| Pre-Press Mold | 1.5" x 1.5" Square |
| Cylinder | |
| Filter Bags | 2" x 3" (36, 72, 90, 120 micron or Mixed options) |
| 2" x 4" (36, 72, 90, 120 micron or Mixed options) | |
| 2" x 4.5" Value Pack (36, 72, 90, 120 micron or Mixed options) | |
| 2" x 200" Filter Tube (36, 72, 90, 120 micron mesh options) | |
| Parchment Paper | 10" x 7" pre-cut, 50 sheets per set |
| 12" x 15" pre-cut, 100 sheets | |
| 6" x 8" PTFE sheets, 12 total | |
| Tool set | Cleaning Tool Kit |
| Cooling Plate | 6" x 8" Cooling / Warming Plate |
* This is a suggested amount. Some customers report pressing up to 5 grams per load.
Â
Control Panel Setting: universal for all Rosineer presses
